GT6 Mk3 valance

GT6 front panels and bumper

Here i am fitting the front panels and bumper to my Triumph GT6 Mk3.  Unfortunately i have had to fit an old bumper for now.

In these picture I am trial fitting the front valance so I can line up some brackets to be welded on.  These will be the mounting points for the front numberplate.  GT6 Mk3 valance

The front indicators are installed and working after a few hours tracking faults in the loom.  Hazard light were a pain.  I got there in the end after finding the green/red and Green/white wires from the switch to the bulbs had internal breaks in the loom.

I am trying to get the car ready to move to another location.  Ideally I would like to have the valance painted and on.  Also with the bonnet fitted and aligned.  The difficulty is in getting the bonnet to the car.  I might resort to putting it on a roof rack.

GT6 rear end view
Gt6 MK3 rear end view as the car starts to come together
GT6 MK3 bonnet fitted
GT6 MK3 bonnet fitted

4 thoughts on “GT6 front panels and bumper”

  1. Terrific article! This is the kind of information that are
    supposed to be shared across the internet. Shame on the seek engines for not positioning this put up upper!
    Come on over and seek advice from my web site .
    Thanks =)

  2. Sir I have an opportunity to purchase a 68 gt6 it is all there but in parts would this be a good buy for 6000 us. I don’t think all the parts are the same vin but that realy doesn’t matter to me. Body needs work bonnet doesn’t fit right so will need body work.
    Thanks for the wonderful sight it has given me very good ideas if I purchase the car

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.